Stangkiller - Chris Wetmore
Procharger, Comp Cam, Alky Injection, Z06 trans, 3.73 gears spec clutch LT headers X-pipe & B&B PRTs
Tony Zagata - 2006 C6 Corvette
Built by Fast Track Performance
365 cu in ls2 forged motor, custom 88mm rear mount turbo kit, PI converter, RPM stage 5 4l60e w/transbrake, RPM refreshed rear differential.
Car has been a best of 9.96 at 143 and 6.58 at 113 60'ing a 1.55-1.60 on 18 inch drag radials.
John Welch, Jr. - Bowtie8
434 c.i. mini-ram, 9 inch Ford rear, Big Stuff 3, RPM 4L80E w/transbrake, Vigilante 4200 lockup, 20 mpg
10.32@133
John Welch, Sr.
427 - Phil Hoefler Skunk Werkz built and tuned
ET LS7 Heads
Rpm 4L65E an PI 2200 stall
RPM 3.73 gears
10,90 129 mph 1,53 60 ft
Jim Mosher
04 Z06, RPM Level V, A&A Forged 402 shortblock, Patriot Heads, Procharger D1SC, 4.25 Pulley, Dynatech Headers and X-Pipe, ECS Fuel System, Stock TI Mufflers, 710rwhp/668rwt on Mustang Dyno.
Dwayne Schultz
402 Stroker
RPM Level V 4L65E
3,73 diff w/DTE Brace
150 NX Shot, etc.
9,97 @ 137.69 - on the juice
10,82 @ 123 - NA
Jim Robinson - 1971 Chevelle
Custom everything. LS7 427 wired by Speartech. 4L70E transmission by RPM Transmissions.
Kerry Daniels - Thank you for the transmission, it runs and shifts perfect. feels better than when the car was brand new. This is the second Corvette I have put one of you transmissions into. I am very pleased with your service and the performance of you work.
thank you again
James Kinsler
Troy Finner
Phil - phil97svt
1999 Corvette Coupe
Current Motor LS6/346
ET Performance 11 degree 240cc heads, 254/260 Solid Roller .650 lift 112lsa - Jesel J2K Rockers, Diamond -2cc 11 degree / Forged 4340 H-Beam Rods, Nitrous Express Direct Port
Jim Lankford
2003 ZO6
NX Wet Kit with Gen2X upgrade, Halltech Intake, LG Headers, B&B Bullets, RPM M12 T56, DTE Stage 3 with 3.90, Textralia Clutch, few other mods
Wayne Grubb - I now have Quickest bolt on C5 A4 Coupe in Country as of Track Day there. 11.69 ET. 3500 pounds -Yank ss3800 converter - Jet Hot Headers - B&B Route 66 exh - M/T Drag Radials -Tuned by Me with HP Tuner.
Zaki Ali - LPE supercharged with an RPM differential along with many other upgrades.
Mick Melberger - Z06, RPM A6 conversion
Hussam Tawfiq - RPM Level IV T56 built 346ci HEADS/CAM and 16psi STS Twin Turbo 700rwhp 670rwtq
The new single Turbo setup should be over 800rwhp
Michael Damman - 2001 Z06 with the following: Forged 383, A&A Vortech supercharger, RPM differential, and lots of other stuff...
Gorillavette - C5 twin turbo 434 LSX engine. RPM level V transmission with all options. RPM differential Stage III all options with quaife. Driveshaft shop axles and carbon fiber drive shaft. McLeod Triple MEBA clutch. Dyno 1012rwhp, rear wheel torque 976.
Glen Piller - 2001 Corvette
Forged 347, AFR 205 Heads
RPM Level V transmission
RPM Level III Differential
TTi Stage X @ 16#
ECS fuel system
Tuned by ADS in Chandler AZ
10.59@149 mph (on street tires & 13#)
Z06Wanted - Shane
I have your Level 6 4L65 conversion for my 03 Z, Coan converter, right and left shafts, SFI bell housing, Flexplate, TTIX LS3 418 708rwh on 9.5 psi
Kevin Wright --
Headers with catted y, tune, exhaust, cold air intake, 3200 stall, rpm level VI transmission and soon a cam
